Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Remove all packaging, including straps, before using the grill
WARNING: IMPORTANT BEFORE LIGHTING...
Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the grill if the odor of gas is present. Only the pressure regulator
and hose assembly supplied with the unit should be used.
Never substitute regulators and hose assembly for those supplied with the grill. If a replacement is necessary,
contact the manufacturer for proper replacement. The replacement must be that specified in the manual.
WARNING: Always keep your face and body as far away from the burner as possible when lighting.
GENERAL USE OF THE MAIN BURNER
Each main burner is rated at 4.4kW. The main grill burners encompass the entire cooking area and are side
ported. The burner knobs are located on the control panel. Each ignition setting is labeled on the control panel.
Each burner assembly is adjusted prior to shipment; however, variations in the local gas supply
may make minor adjustments necessary.
Do not attempt to light the grill if odor of gas is present.
Check all gas connections before each use.
MAIN BURNERS
TO LIGHT THE MAIN BURNERS
1.
Turn ON the gas tank valve.
2.
Push and turn corresponding burner control knob to the
pressing the ignition button to light the burner.
3.
Once the burner is lit, release the ignition button and knob.
If burner does not light up, turn the knob to O and repeat the lighting
4.
procedure.
9
Lighting Instructions
while
Publicidad
