ST MP 500 Li 48 Manual De Instrucciones página 130

– sectioning pallets, crates and
various packing materials;
– sectioning furniture or other materials with
nails, screws or other metal components;
– butchering meat;
– using the machine to cut materials other than
wood (plastic materials, building materials);
– using the machine to lift,
move or split objects;
– using the machine while
fastened to fixed supports;
– using cutting means other than those
found in the "Technical Data" table.
Serious injury and wound hazard.
– using of the machine by more
than one person.
IMPORTANT Improper use of the machine
will invalidate the warranty, relieve the
Manufacturer from all liability, and the user
will consequently be liable for all and any
damage or injury to himself or others.
3.1.3 User types
This machine is intended for use by
consumers, i.e. non-professional operators.
It is intended for "DIY" use only.
3.2 SAFETY SIGNS
The machine has various symbols on it (fig. 2).
They are used to remind the operator of the
behaviour to follow to use it with the necessary
attention and caution.
Meaning of symbols:
Warning! Read the instructions
before operating the machine.
Warning! The failure to use
this machine correctly can be
hazardous for oneself and others.
Danger! Do not leave
the machine in the rain or
in damp conditions.
Danger! Always wear protective
gloves when using the chainsaw.
Warning! Falling objects.
Keep any persons on site
at a safe distance.
IMPORTANT
decals must be replaced. Order replacement
decals from an authorised service centre.
3.3 IDENTIFICATION LABEL
The identification label holds
the following data (fig. 1):
1. Sound power level
2. CE conformity marking
3. Month/Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
8. Voltage and Frequency of power supply
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever
you contact an authorised service centre.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (fig. 1):
A. Motor: supplies the drive power
to the cutting means.
B. Control Rod: hand grip fitted with
the main throttle controls.
EN - 6
Danger! Electrocution. Keep
a distance of at least 15 m
from overhead line cables.
Danger! Always wear protective
equipment for the head.
Danger! Wear anti-
slip safety boots
Danger! Wear protective
earplugs and goggles.
Danger! Wear protective clothing.
Any damaged or illegible