ST MP 500 Li 48 Manual De Instrucciones página 132

4.3 ASSEMBLY OF PRUNER DEVICE
Perform all operations after
removing the battery.
• Insert the control rod (Fig. 9.A) in
the pruner device (Fig. 9.B).
• Slide the collar (Fig. 9.C) upwards and
turn it clockwise until it is fully tightened.
Periodically check that the
joints are well tightened.
4.4 EXTENSION OF THE PRUNER DEVICE
Loosen the knob (Fig. 10.A) following the
direction of the arrow - open padlock;
• pull or push the rod (Fig. 10.B) until it
reaches the desired length;
• when the adjustment is complete, tighten
the knob following the direction
of the arrow - closed padlock.
Periodically check that the
joints are well tightened.
4.5 REMOVING THE PRUNER DEVICE
• To remove the pruner device (Fig. 9.B),
place the control rod (Fig. 9.A) on the
ground, loosen the collar (Fig. 9.C) and
disassemble the pruner device.
5. CONTROLS
5.1 SAFETY BUTTON (ACTIVATION /
DEACTIVATION DEVICE) FIG. 11.C)
Press this button to activate
and deactivate the machine's
electrical circuit.
One LED on: the machine's
electrical circuit is activated.
The machine is ready for use.
Both LEDs on: the machine is in action.
LED off: the electrical circuit
is completely deactivated.
IMPORTANT Do not keep
your finger on the button when
moving the machine to avoid
accidentally enabling the machine.
The "Attention" icon lights up in case of
mechanical failure of the machine (see
the Troubleshooting table, par.. 14).
5.2 THROTTLE TRIGGER LEVER
The throttle trigger lever (Fig.11.A)
allows the activation of the chain.
The activation of the throttle trigger lever
(Fig. 11.A) is only possible if the throttle
lock lever is pressed (Fig. 11.B).
5.3 THROTTLE LOCK BUTTON
The throttle lock button (Fig. 11.B) allows the
throttle trigger lever to be used (Fig. 11.A).
6. USING THE MACHINE
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or dangers.
IMPORTANT For instructions
regarding the motor and the battery (if
supplied), read the relevant manuals.
6.1 PRELIMINARY PROCEDURES
Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
6.1.1 Checking the battery
• Before each use:
– check the battery charge status according
to the instructions in the battery booklet.
6.1.2 Using the harness
The machine must always be used
connected to the harness correctly worn
when using the extension rod. Frequently
check the efficiency of the quick release
in order to free the machine quickly
from the belts in the event of danger.
The harness must be put on before
connecting the machine to the special
coupling and the belt must be adjusted
to suit the operator's height and build.
• The belt (Fig. 12.A) must go from
the left shoulder to the right hip.
• Hook the carabiner (Fig. 12.B) to the special
coupling located on the control rod.
EN - 8