Ametek Next Gen PCS Manual Del Usuario página 31

II. INSTALLATION INSTRUCTIONS
1. Next Gen PCS Installation:
a. Turn off the machine you are connecting to the Next Gen
PCS Filter, and unplug the machine' s power cord from
wall outlet.
b. Connect Modem/Fax line: Connect a phone cord from the wall jack to the "Modem/Fax"
modular jack labeled "IN", and then connect a second phone cord from the "Modem/Fax"
modular jack labeled "OUT" to the machine/equipment to be protected.
Please Note: The Next Gen PCS Filter series only provides connectivity and protection for a
single phone line – connecting the Filter to a phone jack with 2 lines using
4-conductor telephone cable may cause Filter malfunction, detailed in
Section: " Troubleshooting/Next Gen PCS Filter".
c. Connect "10/100/1000 ETHERNET" network line: Connect a CAT5e network cable from
the wall jack to the "10/100/1000 ETHERNET" modular jack labeled "IN", and connect a
second CAT5e network cable from the "10/100/1000
ETHERNET" modular jack labeled "OUT" to the equipment to be protected.
One CAT5e network cable is included with the Next Gen PCS Filter.
© 2024 AMETEK Electronic Systems Protection / Soporte técnico: 1-800-645-9721 / espsurgex.com
User Manual
29