Publicidad
Idiomas disponibles
Idiomas disponibles
b. Clearing Memory:
© 2022 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com
The Next Gen PCS Filter is able to timestamp the 60 most recent power quality events
(information stored in microcontroller non-volatile memory). The microcontroller memory
contents can be cleared at any time by following one of these two methods:
i. RST Button:
There is a recessed push button located on the far right of the front endplate (the
end plate that contains the RJ45 and RJ11 and modular jacks).
Follow these steps to clear the device memory:
1.
Unplug the input cord of the Next Gen PCS Filter from the branch circuit
outlet.
2.
Using a paperclip or small screwdriver, press and hold the RST
button.
3.
Plug the input cord of the Next Gen PCS Filter into a properly grounded and
compatible branch circuit outlet, while continuing to hold the RST button.
4.
Wait approximately 3-5 seconds; the LCD Event Monitor will now display
"cLr"; release the RST button and the device microcontroller memory will
now be cleared.
ii. Diagnostic Software:
The device microcontroller memory may alternately be cleared from within the
Diagnostic Software. See Section: "Using the Software" for details.
User Manual
34
Publicidad
