Publicidad
Idiomas disponibles
Idiomas disponibles
Operating this unit
2
Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween Rear SP :F.Range (full-range speaker)
and Rear SP :S/W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :F.Range.
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S/W.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
30).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1
Use MULTI-CONTROL to select Mute.
2
Press MULTI-CONTROL to switch the tel-
ephone muting/attenuation.
Pressing MULTI-CONTROL will switch be-
tween TEL ATT (attenuation) and TEL mute
(muting) and that status will be displayed.
Switching the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1
Use MULTI-CONTROL to select
Demonstration.
2
Press MULTI-CONTROL to turn the fea-
ture demo on.
# To turn the feature demo off, press
MULTI-CONTROL again.
Notes
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
! You can also turn on or off feature demo by
pressing DISPLAY while this unit is turned off.
For more details, see Feature demo mode on
page 8.
Switching the reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds.
1
Use MULTI-CONTROL to select
Reverse mode.
2
Press MULTI-CONTROL to turn the re-
verse mode on.
# To turn the reverse mode off, press
MULTI-CONTROL again.
Note
You can also turn on or off reverse mode by press-
ing BAND while this unit is turned off. For more
details, see Reverse mode on page 8.
Section
02
35
En
Publicidad
