JMA SUPRACODE Manual De Instrucciones página 35

• Each stored cutter has a cutter-holder (1) with its name
inscribed. This makes it easier to locate the cutter needed for use at any time.
Furthermore, each cutter family is differentiated by background colours:
BLACK: for slot or sidewinder keys
BLUE: for dimple keys (penetration machining)
BLUE / WHITE: for dimple keys (circular interpolation machining)
NOTE: The SUPRACODE machine is supplied with a sufficient number of
cutters to be able to cut the vast majority of keys on the market. Nevertheless,
if at any time the machine user considers that they require a new cutter
reference, and they also want to keep it in the tool magazine, a cutter-holder
can be supplied on which the corresponding identification label can be placed.
A template is supplied with each machine with a full set of identification
labels suitable for placing on the cutter-holder.
• To remove the cutter from the tool magazine, grip the cutter-holder (1) with
the fingers and pull outwards.
• To remove the cutter from the cutter-holder, hold the cutter with the fingers
and pull outwards.
• Once the cutter is installed on the machine's head, it is recommended to
leave its corresponding cutter-holder (1) in the opening for the holder of the
cutter in use (5). In this way, the cutter being used on the machine can be
easily identified.
• To help insert the cutter in the opening of its corresponding cutter-holder,
it is recommended to slightly rotate the cutter-holder at the same time as
pushing it into its opening.
4.3 TRACER REPLACEMENT
1) Lift the transparent protector from the machine.
2) Pull the knob (T8) and lower it to its lowest position.
3) Unscrew screw (T19) with a 2 mm Allen key and remove the
tracer (P) by pulling it downwards.
4) Insert the new tracer (P) into its corresponding opening and
push until it reaches the internal stop.
5) Continue to push the tracer (P) upwards and secure it by
means of the screw (T19).
4.4 ENGRAVER REPLACEMENT
1) Lift the transparent protector from the machine.
2) Unscrew the screw (T20) with a 2 mm Allen key and remove the engraver
(G) by pulling it downwards.
3) Insert the new engraver (G) into its corresponding opening and push until
it reaches the internal stop.
4) Continue to push the engraver (G) upwards and secure it by means of the
screw (T20).
4.3
T19
4.4
T20
G
4.5 INSTALLATION OF THE ENGRAVER BLOCK
Depending on the machine version, it may have been supplied without the
engraver block.
However, an engraver block to use in the machine can be supplied as an
accessory at any time.
Proceed as follows to install it in the machine:
1) Lift the transparent protector from the machine.
2) Remove the small plug (T4)
3) Unscrew the screw (T5) using a No 3 Allen key.
4) Remove the cover (F)
5) Insert the engraver block (BG) and lock it from the bottom by means of
the set screw (T1).
SUPRACODE
KEY CUTTING MACHINE
T8
P
35