Practical Applications - Metabo HPT C 12LDH Manual De Instrucciones

English

PRACTICAL APPLICATIONS

WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the tool
is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 23).
Line
1. Switch operation
Lock-off button
Fig. 24
WARNING:
2. Using the Vise Assembly (Standard accessory)
Screw holder
6mm wing
bolt (B)
Fence
Vise shaft
6mm wing bolt (A)
Fig. 25
WARNING:
CAUTION:
16
Warning sign
The tool will not start unless the Lock-off button is pressed while the switch is
pulled back.
The Lock-off button can be engaged by pressing it from the left.
After the switch is on, the saw blade will continue to operate as long as you
pull on the switch trigger, even if you release the Lock-off button.
When the switch is released, the Lock-off button automatically disengages to
prevent inadvertent motor startup.
Switch trigger
Never lock the Lock-off button in depressed position.
Pulling back the switch would then cause the tool to suddenly start operating, which
could result in injury.
(1) The vise assembly can be mounted on either the left fence
Knob
(2) The screw holder can be raised or lowered according to the
Vise plate
(3) Turn the upper knob and securely fi x the workpiece in position
Workpiece
Always fi rmly clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
Always confi rm that the motor head (see Fig. 1) does not contact the vise assembly
when it is lowered for cutting. If there is any danger that it may do so, loosen the
6 mm wing bolt (B) and move the vise assembly to a position where it will not contact
the saw blade.
Fig. 23
{Fence (B)} or the right fence {Fence (A)} by loosening the 6mm
wing bolt (A).
height of the workpiece by loosening the 6mm wing bolt (B).
After the adjustment, fi rmly tighten the 6mm wing bolt (B) and fi x
the screw holder.
(Fig. 25).
Line
Warning sign