English
31. DO NOT STOP COMPRESSOR BY PULLING OUT THE
PLUG.
This could result in damage to the unit.
Use the "ON/OFF" knob of pressure switch.
32. MAKE SURE THE COMPRESSOR OUTLET PRESSURE
IS SET LOWER THAN THE MAXIMUM OPERATING
PRESSURE OF THE TOOL.
Too much air pressure causes a hazardous risk of
bursting.
Check the manufacturer's maximum pressure rating for air
tools and accessories. The regulator outlet pressure must
never exceed the maximum pressure rating.
33. THE SAFETY VALVE MUST WORK PROPERLY.
Risk of bursting. Before starting the compressor, pull
the ring on the safety valve to make sure that the safety
valve operates smoothly. If the safety valve does not
work properly, over-pressurization may occur, causing
air tank rupture or an explosion. Do not use compressor
if the safety valve is stuck or does not operate smoothly.
Have defective safety valve replaced by a metabo HPT
authorized service center.
Repairs should be conducted only by a metabo HPT authorized service center.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
— 6 —
34. USE OF THIS PRODUCT WILL EXPOSE YOU TO
CHEMICALS KNOWN TO THE STATE OF CALIFORNIA.
Some dust created by this product contains chemicals
known to State of California to cause cancer, birth defects
or other reproductive harm. Some examples of these
chemicals are:
– compounds in fertilizers
– compounds in insecticides, herbicides and pesticides
– arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear
approved safety equipment such as dust masks that are
specially designed to fi lter out microscopic particles. Use
of this product will expose you to chemicals known to the
State of California to cause cancer, birth defects and other
reproductive harm. Avoid inhaling vapors and dust, and
wash hands after using. This product contains chemicals,
including lead, known to the State of California to cause
cancer, and birth defects or other reproductive harm.
Wash hands after handling.