ENGLISH
Returning to the charging base
Press the Back home button on the robot or on the app (with a house icon) in order to send
the robot to the charging base. The robot vacuum cleaner will continue vacuuming until it
reaches the charging base.
Manual mode
Select the manual cleaning mode on the app to steer your robot vacuum cleaner manually.
Power level function
Select the power level on the app to control the robot suction power during cleaning
processes. There are 3 suction power levels: Turbo, Normal and Eco.
Cleaning scheduling
To make cleaning easier, the robot has a function that allows it to be programmed daily from
the app. According to the setting, the robot will automatically start cleaning in the selected
days at the desired time.
5. CLEANING AND MAINTENANCE
High-efficiency filter. Fig. 24
-
The high-efficiency filter is designed with fibres that help trap dust particles, dust
mites, pollen... It is very important to periodically clean the filter, to avoid these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
-
It is recommended to replace the high-efficiency filter with a new one without exceeding
160 cleaning hours.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can
reach the robot motor and damage it.
44