harshest dirt. When using this accessory, water will automatically come out as low-pressure
spray. This accessory is attached to the trigger gun.
EasyClean brush (special for gaskets)
This mode also includes a cleaning brush which, combined with water and soap, helps remove
stains and allows for a more efficient cleaning. When installing and using this accessory, water
will automatically come out as spray, at low pressure. This accessory is attached to the trigger
gun.
2-spin brush (special for floors)
This accessory is installed on the lance of the product and consists of hard bristles. When
activated, it rotates while emitting water at high pressure, making thorough cleaning possible
in the most convenient way. It is designed to clean the patio, garden floor or floors in general.
Fig 8
Cleaning process
The following cleaning procedure will help you organise and ensure you get the best results.
Remember to follow the previous advice.
Preparing the surface
-
Clear the area of furniture and check that windows and doors are securely closed.
-
Also make sure that plants and trees near the area to be cleaned are protected with a cloth.
Initial high-pressure rinse
Spray the area to be cleaned with water to clean any dirt that may have accumulated on
the surface. Before pressing the trigger, move the spray nozzle to the spray mode position
and progressively move it to the desired spray position. This way, you will avoid applying an
excessively direct jet on more delicate surfaces.
Using soap
Water and soap must be used in a 1:19 ratio: 5.4% soap, 94.6% water.
Warning
Use only soaps designed for pressure washers.
-
Test the soap in an inconspicuous place before using the product.
-
Loosen the cap of the soap bottle and fill it with water and soap.
-
Replace the cover.
-
Disassemble the lance from the trigger gun.
-
Attach the soap bottle to the trigger gun. Fig. 9
-
Apply soap in such a way to cover the whole surface to be cleaned. Apply it from bottom to
HYDROBOOST 2000 CAR&GARDEN PRO
ENGLISH
75