RIDGID R4520 Manual Del Operador página 18

ASSEMBLY
SECURING THE DUST CHUTE TO THE SAW
CABINET
See Figures 9 and 10.
 Locate the following from the large fastener pack:
Screws (M5, self-tapping) ............................................. 2
 Lift the back of the dust chute up and align the holes in
the chute with the holes at the back of the saw cabinet.
NOTE: The dust chute is shipped inside of the saw cabinet
and the front of the chute is preassembled.
 Install screws and tighten securely.
 Replace the rear panel and secure with bolts.
INSTALLING THE TABLE EXTENSIONS
See Figure 11.
 Locate the following from the large fastener pack:
Bolts (M10 x 25 mm) ..................................................... 6
Lock washers (M10) ...................................................... 6
Flat washers (M10)........................................................ 6
 With the table saw in the upside down position, place the
left side extension against the table top on the side where
the power cord exits. The larger holes in the extension
should be aligned with the holes in the saw table.
NOTE: The left table extension is narrower than the right.
 Make sure the edges of the table extension are aligned
with the edges of the table.
 Insert a lock washer and flat washer over a bolt. Thread
the bolt through the holes in the table extension and into
saw table. Repeat for the two remaining holes.
 Repeat above step on the right table extension.
 Using an 8 mm socket, tighten the bolts. Do not tighten
completely.
SCREW
DUST
CHUTE
LEFT
TABLE
EXTENSION
BOLT
18 - English
SCREW
SAW
TABLE
Fig. 10
RIGHT TABLE
EXTENSION
SAW
TABLE
FLAT
WASHER
LOCK
WASHER
Fig. 11