Concept TM5500 Manual Del Usuario página 22

EN
WHIPPING
Use the whisk attachment, whipping whisk and double whisk only for whipping cream, egg whites, preparing runny
sponge mixture and no-bake desserts.
Use a wide bowl.
Whip a maximum of 400 ml of chilled cream (min. fat content 30 %, 4-8 °C).
Whip a maximum of 4 egg whites.
1. Put foods in a wide bowl.
2. Place the appliance body on the transmission shaft of the whisk attachment and turn it to lock it.
3. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
4. Hold the appliance body with one hand and the whipping bowl with the other.
5. Insert the appliance into the whipping bowl with foods and press the switch to switch it on. Whip in a circular
motion at the bottom of the bowl and keep turning the bowl clockwise. You can use the Turbo button and briefly
increase the motor speed to maximum.
6. After you have finished whipping, switch off the appliance. Unplug the power cord from the socket.
7. Press the release buttons on the bottom of the appliance to remove the whipping whisk and rinse it immediately
under warm running water. Make sure that water does not get into the inside of the attachment to the drive shaft
area. If this happens, allow the whisk attachment to dry and drip a few drops of edible oil into the drive shaft area
to ensure better run of the whisk attachment bearing.
PURÉE (model TM5500, TM5510 only)
The purée attachment is suitable for processing boiled potatoes, carrots and other vegetables. Do not use foods that
are too hard.
1. Put the foods evenly in a larger bowl.
2. Place the appliance body on the shaft of the purée attachment and turn it to lock it (pull it make sure that the purée
attachment cannot be separated from the appliance body).
3. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
4. Hold the appliance body with one hand and the bowl with foods with the other.
5. Insert the appliance into the bowl with foods and press the switch to switch it on. The power can be increased to
Turbo. Use the attachment to slowly press the foods until the desired consistency is reached.
6. After you have finished blending, switch off the appliance. Unplug the power cord from the socket.
7. Press the release buttons on the bottom of the appliance to remove the puree attachment from the body of the
appliance and rinse the attachment in warm flowing water immediately. Make sure that water does not get into the
inside of the attachment to the drive shaft area. If this happens, allow the attachment to dry and drip a few drops
of edible oil into the drive shaft area to ensure better run of the attachment bearing.
42
FOOD PROCESSOR (model TM5500 only)
The food processor can be used not only as a large chopper, but also as a grater. You can insert the plate of your choice
into the grating attachment.
1. When chopping, place the chopping blade on the shaft inside the bowl and then add the foods. Press the button
just below the top bend of the bowl handle, this will allow you to put on the transmission lid. Turn the lid in the
correct direction to lock it in its place.
2. When grating, insert the selected plate into the grating attachment. Place this attachment on the shaft inside the
bowl. Press the button just below the top bend of the bowl handle, this will allow you to put on the transmission
lid. Turn the lid in the correct direction to lock it in its place.
3. Place the appliance body on the lid and turn it to lock it (pull it make sure that lid cannot be separated from the
appliance body).
4. Unwind the power cord completely. Make sure it does not touch any nearby heat sources. Insert the plug into the
wall outlet.
5. Hold the appliance body with one hand and the food processor with the other.
6. When grating, put the foods in the feed tube using the pusher only.
7. Press the switch to switch on the appliance. Press to select the chopping and grating speed. The power can be
increased to Turbo.
8. After you have finished, switch off the appliance. Unplug the power cord from the socket.
9. Press the release buttons on the bottom of the appliance to remove the lid from the body of the appliance and wipe
the lid with damp cloth. Do not wash under running water or immerse in water!
GRATING (model TM5500, TM5510 only)
1. Place the lid with graters on the grater bowl.
2. Then place the grater holder and turn to secure the holder in place.
3. Fit the body of the appliance into the upper part of the tamper.
4. Put the product on the grater holder and process it using the tamper
5. Press the switch to switch on the appliance. Press to select the grating speed.
6. Switch off the appliance after completion of the food processing operation. Unplug the power cord from the
socket.
7. Press the button below the upper part of the bowl holder and turn the lid to remove it from the body of
the appliance. Wipe with a damp cloth, do not wash in flowing water or immerse in water!
EN
43