Grandstream GWN7830 Guía De Instalación Rápida página 3

OVERVIEW
EN
The GWN7830 is Layer 3 aggregation managed switch that allows medium-to-large enterprises to
build scalable, secure, high performance, and smart business networks that are fully manageable. It
provides 2 10/100/1000Mbps Ethernet ports, 6 SFP ports and 4 SFP+ ports with a maximum switching
capacity of 96Gbps. It supports advanced VLAN for flexible and sophisticated traffic segmentation,
advanced QoS for prioritization of network traffic, IGMP/MLD Snooping for network performance op-
timization, and comprehensive security capabilities against potential attacks. GWN7830 can be man-
aged in a number of ways, including the local Web user interface of the GWN7830 switch and CLI,
the command-line interface. And also supported by GWN.Cloud and GWN Manager, Grandstream's
cloud and on-premise network management platform. With complete end-to-end quality of service
and flexible security settings, the GWN7830 is the best value enterprise-grade managed switch for
medium-to-large businesses.
PRECAUTIONS
• Do not attempt to open, disassemble, or modify the device.
• Do not expose this device to temperature outside range of 0 °C to 45 °C for operation and -10 °C to
60 °C for storage.
• Do not expose the GWN7830 to environments outside of the following humidity range: 10-90% RH
(non-condensing) for operation and 10-90% RH (non-condensing) for storage.
• Do not power cycle your GWN7830 during system boot up or firmware upgrade. You may corrupt
firmware images and cause the unit to malfunction.
PACKAGE CONTENTS
1x GWN7830 Switch
1x Power Cord Anti-Trip
1x 1.2m (10A) AC Cable
PORTS & LED INDICATORS
Front Panel
3
1
2 4
Back Panel
10
1x 25cm Ground
4x Rubber
Cable
Footpads
2x Extended Rack Mounting Kits 8x Screws (KM 3*6)
5
7
6
11
~ 1 ~
No. Port & LED
1 Ports 1-2
2 1-2
3 Ports 3-8
4 3-8
5 Ports 9-12
6 9-12
7 Console
8 RST
9 SYS
10
11 100-240VAC
50-60Hz
12
LED Indicator
LED Indicator
1x Quick
Installation Guide
System Indicator
Port Indicator
POWERING & CONNECTING
Grounding the Switch
8
1. Remove the ground screw from the back
9 of switch, and connect one end of the
ground cable to the wiring terminal of
switch.
2. Put the ground screw back into the screw
hole, and tighten it with a screwdriver.
3. Connect the other end of the ground
12
cable to other device that has been
grounded or directly to the terminal of the
ground bar in the equipment room.
Description
2x 10/100/1000Mbps Ethernet ports
Ethernet ports' LED indicators
6x 1Gbps SFP ports
SFP ports' LED indicators
4x 10Gbps SFP+ ports
SFP+ ports' LED indicators
1x Console port, used to connect a PC directly to the switch and manage it.
Factory Reset pinhole, press for 5 seconds to reset factory default settings
System LED indicator
Power cord anti-trip hole
Power socket
Grounding terminal
Status Description
Off Power off
Solid green Booting
Flashing green Upgrade
Solid blue Normal use
Flashing blue Provisioning
Solid red Upgrade failed
Flashing red Factory reset
Off Port off
Solid green Port connected and there is no activity
Flashing green Port connected and data is transferring
Ground Terminal
Ground Bar
~ 2 ~
Ground Cable