Nilox C3 Manual Del Usuario página 95

Handlebar
The bicycle is equipped with a handlebar stem called
''Aheadset'', you can adjust the height of the stem by
increasing or removing the adjustment rings located between
the stem and the upper steering bearing.
The inclination of the steering column can be adjusted by
acting on the screw indicated in the image to the side.
It is recommended that these operations be carried out by a
qualified technician.
Make sure the handlebar is perpendicular to the front wheel
axle.
ATTENTION: The handlebar can have a negative influence on
the response time of the cyclist during braking and in turns.
Tires
Check tire pressure regularly. Driving with under-inflated or over-inflated tires can affect performance,
cause premature wear, reduce range or increase the risk of an accident.
If significant wear or a nick is visible on one of the tires, replace it before riding the bike. A pressure
range is indicated on the sidewall of the tire by the manufacturer and in the following table. The
pressure must be adapted according to the weight of the user.
Model
City Cargo
Method for determining correct adjustment of quick-release mechanisms (wheel and seat clamp)
Quick release devices are designed to be operated by hand. Never use tools to block or unblock the
mechanism so as not to damage it.
To adjust the clamping force of the wheel axle, you must use the adjusting nut and not the quick
release lever. If the lever can be moved with minimal hand pressure, it is not tight enough. It is
therefore necessary to tighten the adjusting nut.
The quick-release system must mark the fork dropouts when closed in the locked position.
Bike size Air chamber size
20" 20x2.25
27.5" 27.5x2.20
Pressure
Tire size PSI
20x2.25 30 – 50
27.5x2.20 40 - 65
Bar
2.0 – 3.5
2.8 – 4.5
95