cecotec IRONHERO 3000 SAUNA I-PUMP Manual De Instrucciones página 35

Before first use
WARNING: remove adhesive stickers and any other plastic or cardboard packaging from the
soleplate. Be sure to remove all stickers by rubbing the soleplate with a cloth dampened with
methyl alcohol. Rinse the water tank: fill and empty it to remove any possible manufacturing
residues.
NOTE: when the iron is switched on for the first time, it may release steam for up to 10 minutes
due to the heating of the manufacturing residues. This is normal and does not impair the
operation of the iron.
Filling up the water tank
Before filling the iron's water tank, make sure that it is switched off. It is possible to fill the
water tank before or during use. To do this, place the iron in an upright position and open the
tank cover; slowly pour the water through the filling hole without exceeding the maximum
capacity of the tank. Put the tank cover back on.
Using the iron
Connect the iron to a power supply and turn it on.
Adjustment for synthetic, silk, and wool garments
If you want to iron dry, it is not necessary to fill the tank. If you want to dry iron and there is
water in the tank, empty it before use.
1. Plug in the iron and switch it on.
2. After switching on, the indicator light on the iron will light up steadily.
3. Turn the temperature knob from OFF to the desired position: Synth, Silk, or Wool.
4. Once preheating is complete, the indicator light will flash you can use the iron when the
indicator light changes from flashing to steady.
Adjustment for cotton and linen
For more difficult fabrics (such as cotton or wool), use the steam function and always set the
temperature to the maximum setting.
1. Fill up the water tank. Note: Before steam ironing, make sure that the tank is at least 1/4
full.
2. Plug in the iron and switch it on.
3. The indicator light will come on to indicate that the appliance has started up correctly.
4. Turn the temperature knob from OFF to the desired setting: Cotton or MAX/linen.
5. The indicator light will change from flashing to steady to indicate that the iron has reached
the selected temperature setting and you can start using it. With the iron in horizontal
position, press the steam button: the indicator will light up red and the iron will emit
continuous steam.
6. To deactivate the continuous steam function, press the steam button again: the indicator
light will go out.
IRONHERO 3000 SAUNA I-PUMP
ENGLISH
35