Publicidad
Idiomas disponibles
Idiomas disponibles
Battery (Fig. 1.G)
Cooling air ducts (par. 7.3) Not clogged
Machine
Throttle control lever
(Fig. 10.A), throttle
safety lever (Fig. 10.B)
Test driving
6.2.2 Machine operating test
Action
1. Fit the battery inside its
housing (par. 7.2.3 );
2. Press the safety
button (Fig. 10.C)
1. Start the machine
(para. 6.3 );
2. Simultaneously
activate the throttle
control lever (Fig. 10.A)
and the throttle safety
lever (Fig. 10.B);
3. Release the throttle
control lever (Fig. 10.A)
and throttle safety
lever (Fig. 10.B).
Press only the throttle
control lever (Fig. 10.A).
If any of the results fail to match
the indications provided in the tables
below, do not use the machine! Take
it to a service centre to be checked
and repaired if necessary.
6.3 START-UP
6.3.1 Start-up with battery
1. Make sure the cutting means is not
touching the ground or any other object;
2. Insert the battery correctly
housing (Fig. 16.B) (par. 7.2.3);
3. Simultaneously activate the throttle
control lever (Fig. 10.A) and throttle
safety lever (Fig. 10.B).
NOTE At every start up new line is
automatically released (par. 6.4.2).
No damage to the casing,
no liquid leakage
No signs of damage
or wear
The levers must move
freely and not be forced.
No abnormal vibrations.
No abnormal sound
Result
The LED (Fig. 10.D)
must come ON (electrical
circuit activated).
1. The cutting means
must not move.
2. The cutting means
should move.
3. The levers should
return automatically
and rapidly to the
neutral position and
the cutting means
should stop.
The throttle control lever
remains blocked.
in its
6.3.2 Start-up with battery
simulator (if available)
1. Make sure the cutting means is not
touching the ground or any other object;
2. Insert the battery simulator correctly in
its housing on the machine (Fig.16.J);
3. connect the connection cable to
the battery simulator (Fig.16.I);
4. select the battery using the
selector (Fig. 9.B);
5. Press the safety button (Fig. 10.C),
6. engage the blade control lever
Fig. 10.A
(
simultaneously (Fig. 10.B).
6.4 OPERATION
NOTE Before tackling a mowing job
for the first time, get to know the machine,
learn the most suitable cutting techniques,
grip the machine firmly and make the
movements required by the job.
To use the machine proceed as follows:
– always hold the machine firmly with
two hands, using the cutting unit
below the operator's belt level.
NOTE During use, the battery is
protected against total drainage with a
protective device that switches off the
machine and stops it from working.
NOTE The battery power reserve (and
therefore the mowable vegetation area
before recharging is required) depends
on
various factors (par. 7.2.1).
NOTE After one minute of inactivity, if turned
on, the machine will automatically switch off.
6.4.1 Work techniques
Use ONLY nylon lines. The use of
metal lines, plastic coated metal lines and/
or lines that are not suitable for the head
can cause serious injuries and wounds.
a. Cutting motion (Scything)
– Make sure the cutting means is in
grass trimmer mode (par. 6.1.3);
– proceed at a regular pace, with a
circular motion similar to a traditional
scythe, without tilting the cutting line
head during the operation (Fig. 17).
EN - 11
and the safety switch
)
Publicidad
