CASUALPLAY S4 REVERSE Instrucciones De Uso página 17

This exclusive fastening system means that the following accessories can be used on
the S4 Reverse pushchair: Prima, Prima Fix, Baby Zero Plus, Metropol Carrycot,
Playmoon and Mako.
FITTING ACCESSORIES (illustrations 31-33)
NOTE: Before installing any accessory, the Unisystem adaptors for the seat must be
taken off.
• Put the parking brake on.
• Place the Prima, Prima Fix, Baby Zero Plus, Metropol Carrycot, Playmoon or Mako
on the pushchair, facing backwards.
• Line the fasteners of the Prima, Prima Fix, Baby Zero Plus, Metropol Carrycot,
Playmoon or Mako up with their slots (fig.31).
• Press downwards until it clicks indicating it is fastened and a green signal appears in
both of the windows on the sides of the fasteners (fig.32).
• To remove, press and then release the red button on both fasteners (a red signal will
appear in the window) and pull upwards to release the accessory from the chassis of the
pushchair (fig.33).
BRAKE FUNCTIONING (illustrations 34-35).
• The brake lever is on the upper right-hand side of the handlebar (fig.34).
• Press the lever to stop the pushchair and release it to move on.
• Use the handle on the brake lever to adjust the tension (fig.35)
FOLDING THE S4 REVERSE (illustrations 36-40)
• Lift the safety catch (fig.36) and simultaneously slide the two handles to the sides of the
handlebar (fig.37).
• Push the handlebar forwards (fig. 38) until the pushchair is in the position shown (fig.39).
• Make sure that the locking device is correctly fastened. It will click when it is in the
correct position (fig.40).
BASKET
• The basket is clipped onto the lower part of the chassis, to remove it simply undo the
clips and take it off.
• The maximum weight that the basket can hold is 2.5 kgs.
• It is advisable to empty the basket before folding the pushchair.
MAINTENANCE
• From time to time grease the mobile parts with a lubricating product (not grease or oil).
• Inspect the brakes, harness, clips and mechanisms that may become loose or suffer
from wear and tear through use.
• Clean the chassis with a damp cloth (never use abrasive products or solvents). Use a
sponge with warm water and mild detergent on the plastic parts.
• Follow the washing instructions for the fabric parts of the pushchair, let them dry fully
before folding the pushchair. Do the same if the pushchair has been exposed to damp
conditions to prevent mould from forming.
• Do not use accessories that have not been approved by the manufacturer.
• The tyre pressure should be 2 bar.
UNISYSTEM
15