Worx WX038 Manual Original página 11

4.INTENDED USE
The machine is intended for household cleaning or
similar purposes.
5.OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Assembling the machine
NOTE: Make sure the machine is
locked into place before operation.
Connecting the Pet Brush/Dusting
Brush/Crevice Tool
Install the Battery Pack to supply
power to the Vacuum Cleaner.
After using the machine , please
press the Battery Release Button,
then remove the Battery Pack.
OPERATION
ON/OFF
Press the On/Off button to turn the
vacuum on low mode. Press the
On/Off button again to turn off the
vacuum.
NOTE:Please do not use a vacuum
cleaner to vacuum hot objects such
as carbon, cigarette butts, etc.;
liquid substances; sharp objects
such as broken glass; ultra-fine
substances such as lime, cement,
flour, etc.; corrosive liquids such as
disinfectants, acidic and alkaline
cleaning agents, laundry detergents,
etc.; flammable and explosive items
such as gasoline, alcohol, etc.
Otherwise, it may cause damage to
the machine or accidental fire leading
to personal injury.
Adjusting the speed
Press the Speed Control Button to
choose the speed mode.
LED light
When the machine is working, the
LED Light will be on.
AFTER OPERATION
20V Cordless Stick Vacuum Cleaner
Empty the dustbin after each use.
NOTE: Please clean the dustbin
before the debris inside reaches the
MAX line.
Cleaning the dustbin
Press the release button to
completely remove the dustbin.
Remove the filter from the top and
pull out the cyclone. You can rinse
the dustbin with water. Ensure it is
completely dry before reassembling.
Cleaning the Brush Roll
Press the brush roll release button
FIGURE
on the bottom of the floor nozzle
to access the brushroll. Pull out the
brush roll and untangle any hair.
You can also rinse it with water. It is
See Fig. A1
recommended to clean the brushroll
once a month.
CLEANING THE FILTER
See Fig. A2
Press the release button to
completely remove the dustbin.
Remove the filter from the top. Rinse
See Fig. B
the filter with water and ensure it is
completely dry before reassembling.
It is recommended you rinse your
filter every 3 months.
ASSEMBLING THE WALL MOUNT
Choose a hard wall surface. Drill a
pilot hole in the wall, align the wall
mount, insert the screw into the
drilled hole and tighten.
LAGERUNG
Es wird empfohlen, die
Wandhalterung und den Doppel-
Ladegerät 120 cm (47,25 Zoll) über
dem Boden zu platzieren.
HINWEIS: Lassen Sie das Netzkabel
nicht durch scharfe Gegenstände
führen und vermeiden Sie es, das
Netzkabel zum Bewegen des Geräts
zu ziehen, um Beschädigungen am
Netzkabel zu verhindern.
See Fig. C
See Fig. D
See Fig. E1
See Fig. E2
See Fig. E3
See Fig. E4
11
See Fig.
F1, F3
See Fig. F1
EN