Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Connecting drain and electrical
1
Form a"U" shape on the end of the drain hose with the
hose pointed toward the drain. Place the formed end in
a laundry tub or a standpipe and secure with a cable tie
provided in the enclosure package.
2
Place the hook end of the drain hose in the drain
opening. Secure the drain hose with the cable tie
(provided in the enclosure package) to the standpipe,
inlet hose, laundry tub, etc. so the hose does not pull
out from the force of the water.
& NOTE
The standpipe inside diameter must be 1-1/4" (3.2 cm)
minimum. There must be an air gap around the drain hose in
the standpipe. A snug hose fit can cause a siphoning action.
=a IMPORTANT
Check to ensure the power is off at a circuit breaker/fuse
box before plugging the power cord into an outlet.
3
Plug the power cord into a grounded outlet.
Do not, under any circumstances,
cut, remove, or bypass the
grounding prong.
Grounding
type wall
receptacle
Power cord
with 3-prong
\\
grounded plug
4
Turn on the power at the circuit breaker/fuse box.
5
Carefully slide the washer to its final position. Recheck
for level and rock corners for stability.
6
Read the Use & Care Guide provided with the washer.
It contains valuable and helpful information that will
save you time and money.
7
Run the washer through a complete cycle, checking for
water leaks and proper operation.
8
If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your Use
& Care Guide before calling for service.
9
Place these instructions in a location near the appliance
for future reference.
Publicidad
