Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION: Back Mounting
1. Drill Ø1/4" holes into oblong knock outs on back plate (3)
that correspond to Junction Box (10) holes to be used.
2. Feed the transformer input leads through center hole and
make the proper connections. If using 120VAC, connect
the black and white leads to the building utility. If using
277VAC, connect the orange and white leads to the
building utility. Cap off unused wire. If the unit is self-
powered, be sure to snap battery connector together.
3. Feed excess wire into Junction Box and secure back plate
(3) to Junction Box (10).
4. Snap in arrows (5) on EXIT panel (2) as required. Then
snap EXIT panel (2) to housing, top first and then bottom.
INSTALLATION: Side Mounting
1. Attach crossbar (11) to Junction Box (10). Set the crossbar so
that the longer blade is touching the Junction Box.
2. Open the EXIT housing. Feed the transformer input leads
through side hole, being sure to secure wire into wire guides
molded at the edges of the sign.
3. Attach sign to canopy (7) by inserting canopy into sign at an
angle, then twist to secure.
4. Make the proper supply lead connections. If using 120VAC,
connect the black and white leads to the building utility. If using
277VAC, connect the orange and white leads to the building
utility. Cap off unused wire. If the unit is self-powered, be sure
to snap battery connector together.
5. Push excess wire into Junction Box and align holes in canopy
(7) with those in crossbar (11). Using screws supplied, tighten
canopy to crossbar so that canopy is securely fastened and
tight against wall.
6. Snap in arrows (5) to EXIT panel (2) as required. Then snap
EXIT panel (2) to housing, top first and then bottom.
INSTALLATION: Ceiling Mounting
1. Attach crossbar (11) to Junction Box (10). Set the crossbar so
that the longer blade is touching the Junction Box.
2. Open the EXIT housing. Feed the transformer input leads
through top hole, being sure to secure wire into wire guides
molded at the edges of the sign.
3. Attach sign to canopy by inserting canopy into sign at an angle,
then twist to secure.
4. Make the proper supply lead connections. If using 120VAC,
connect the black and white leads to the building utility. If using
277VAC, connect the orange and white leads to the building
utility. Cap off unused wire. If the unit is self-powered, be sure
to snap battery connector together.
5. Push excess wire into Junction Box and align holes in canopy
(7) with those in crossbar (11). Using screws supplied, tighten
canopy to crossbar so that canopy is securely fastened and
tight against ceiling.
6. Snap in arrows (5) to EXIT panel (2) as required. Then snap
EXIT panel (2) to housing, top first and then bottom.
(See Figure 1)
(See Figure 2)
(See Figure 3)
2
Figure 1
Figure 2
Figure 3
Publicidad
