Klarstein ESPRESSIONATA EVO Manual De Instrucciones página 41

Problem
The espresso is too light.
The espresso is too dark.
The portafilter cannot be
locked properly.
The coffee can be
prepared normally, but
there is no milk froth.
The pump does not draw
water.
Note: If you cannot find the cause of the malfunction, contact a specialist
company and do not attempt to repair or disassemble the device yourself.
Possible cause
The powder in the sieve
was not flattened.
Too little powder.
The powder is too
coarse.
The powder in the sieve
was pressed too hard.
Too much powder.
The sieve is dirty.
The powder is too fine.
The water outlet is
clogged.
Too much powder.
The holder is defective.
The steam outlet is
blocked.
The water tank is not
seated properly.
There is air in the hose.
Solution
Press the powder firmly
next time.
Adjust the amount of
powder (see: Frequently
Asked Questions).
Use finer powder.
Don't press the powder
so firmly next time.
Adjust the amount of
powder (see: Frequently
Asked Questions).
Clean the sieve.
Use coarser powder.
Clean the water outlet.
Adjust the amount of
powder (see: Frequently
Asked Questions).
Contact a specialist
company.
Clean the steam outlet
with a small cleaning
brush.
Clean the steam pipe
by adding a vinegar
and water solution to
the water tank (see:
Frequently Asked
Questions).
Insert the water tank
correctly into the device.
When the pump is
running, turn the dial
and drain a sufficient
amount of water.
EN
41