Publicidad
Idiomas disponibles
Idiomas disponibles
3. Operation with timer
The CO
–consumption during the day (light phase) is determined primarily by the plants. In the night (dark
2
phase), the plants excrete CO
harmful. The solenoid valve can be linked to a timer to meet these specific requirements. An elegant solution is
to connect the solenoid valve to the timer that controls the light. The valve is then switched on and off together
with the light.
4. Operation with pH controller
This operation mode should be preferred in comparison to others. It is the most exact and economic version.
Only the exact quantity required is fed into the system. It balances the loss that is, for example, caused by
water movements and aeration. Fluctuations of the pH-values are avoided by an electronic control. This is an
advantage for the creation of a well-balanced environment.
5. Operation with water
The Aqua Medic solenoid valve may also be used for the control of smaller reverse osmosis systems. Some
important points have to be taken care of to avoid mistakes and damages:
The reverse osmosis unit should not exceed the capacity of 150 l/day (35 gpd) of pure water. The small
-
opening of 2 mm will cause pressure drops and decrease the capacity, if used with larger systems.
If used with tap water, the solenoid valve may be blocked by dirt and rust. In order to avoid this, several
-
precautions have to be taken:
The solenoid valve has to be connected between the sediment filter and the RO module to protect it from
-
clogging. The storage tank where the water is collected should have a safety outlet to the drain. If used for
saltwater aquaria, the evaporated water should not be refilled directly from the RO unit. It is recommended
to collect the RO water in a separate tank and to provide the aquarium from this tank.
The solenoid valve may not be operated with saltwater or pure water (reverse osmosis).
-
6. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear i.e: impellers or
drive wheels etc. The original invoice or receipt is required as proof of purchase. During the warranty period,
we will repair the product for free by installing new or renewed parts. This warranty only covers material and
processing faults that occur when used as intended. It does not apply to damage caused by transport, improper
handling, incorrect installation, negligence, interference or repairs made by unauthorized persons. In case of a
fault with the unit during or after the warranty period, please contact your dealer. All further steps are
clarified between the dealer and AB Aqua Medic. All complaints and returns that are not sent to us
via specialist dealers cannot be processed. AB Aqua Medic is not liable for consequential damages resulting
from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
5
–gas. So it is not necessary to provide CO
2
- Technical changes reserved – 01/2019
during the night time, it may even be
2
Publicidad
