Hydas 4691.1.00 Instrucciones Servicio página 10

• Do not bring the connection cable and switch into contact with moisture.
• The control panel becomes warm and must therefore not be covered, so that it could overheat.
• Do not use the device if any parts of it are damaged.
• Unplug the power cord from the wall outlet after use.
• Do not place other heating devices or heat generating objects on the product when it is on.
• Do not use the unit in bed.
• The cable and control unit of the device may cause strangulation and become trip hazards if improperly placed.
The user must ensure that the cables are arranged in a safe manner.
Warnings!
Observe the following instructions to avoid electric shock and to reduce the risk of burns, fire or injury:
• Unplug the power cord for cleaning, or when not in use.
• Connect the power plug only to AC power with line voltages according to the rating plate on the unit.
• Do not use in the bathroom or other rooms with high humidity.
5 | Application
Preparing the heatable back support belt:
If the device has been stored in very cold areas, first warm the device to room
temperature before use.
a Connect the connector plug of the control unit to the support belt.
b Insert the power plug of the control unit into the socket.
c The heated back support belt is now electrically ready for operation.
Put on the heatable back support belt:
Fig. 1: Hold the support belt with the hook and loop closure (inside) in the
right hand and guide it around the back. Pull the two straps sideways away
from the body.
Fig. 2: First fold in the left side and then the right one.
Fig. 3: Then close the hook and loop fastener at any point of the support belt.
Recommendation: wear over underwear.
handling
a By pressing the selector switch on the control unit, each press switches to
the next heating level. The LEDs indicate the selected level.
b After pressing the selector switch in the highest heat level, the unit is
switched off. All LEDs are off.
automatic switch-off
120 minutes after switching on, the heatable back support belt switches off automatically. If it is to be used again,
the process can be restarted by pressing the selection button. The heat is then available again for 120 minutes of
use.
6 | Cleaning
• Disconnect the power plug and ensure that the device cools down.
• Remove the control unit for washing. To do this, disconnect the power cord with the control unit from the
connection of the back support belt.
• Close hook and loop fasteners during washing to avoid damaging other items of laundry. Cleaning is done by
household laundry, according to care instructions.
• Ensure that the back support belt is completely dry before recommissioning or storage.
• Store in a dry and clean place.
7 | Technical data
Model: 4691.1.00
Rated voltage: 220-240 V ~ 50 Hz
Total power approx.: 100 W
10
Fig. 1
Fig. 2
Fig. 3