HOLZMANN MASCHINEN FKS400V32PRO 400V Instrucciones De Servicio página 49

14.3 Electrical connection
Dangerous electrical voltage!
 The machine may only be connected to the power supply and the associated
checks carried out by a qualified electrician or under the instruction and
supervision of a qualified electrician!
HOLZMANN Maschinen GmbH
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
WAR N I N G
www.holzmann-maschinen.at
8. Saw blade
Adjust the cutting height to the maximum
possible level.
Push the sliding table all the way foreward.
Open the saw blade guard.
Fix the drive shaft with the supplied fixing pin (5)
and loosen the flange nut (4) with the saw blade
wrench (6) (left-hand thread!)
Remove flange nut (4) and flange (3)
Place the well cleaned shaft flange (1),saw blade (2),
flange (3) and flange nut (4) on the drive shaft
Fix the drive shaft with the supplied fixing pin (5).
Tighten the flange nut with the saw blade wrench
(6) (left-hand thread!)
NOTE: min. tightening torque: 50Nm
Close the saw blade guard.
9. Scoring saw blade
Adjust the cutting height to the maximum
possible level
Push the sliding table all the way foreward.
Open the saw blade guard
Fix the drive shaft with the supplied Allen screw (6)
and loosen the flange nut (4) with the wrench (6)
(right-hand thread!)
Remove flange nut (4) and flange (3)
Place the well cleaned shaft flange (1), saw blade
(2), flange (3) and flange nut (4) on the drive shaft
Fix the drive shaft with the supplied Allen screw (6).
Tighten the flange nut with the saw blade wrench
(5) (right-hand thread!)
NOTE: min. tightening torque: 25Nm
Close the saw blade guard.
ASSEMBLY
49
FKS400V32PRO_400V