Publicidad
Idiomas disponibles
Idiomas disponibles
•
Never leave your child unattended.
•
For your safety and that of your
child, always place them in the
child seat and fasten them in,
however short the journey.
•
Use the TITANO i-Size only on
a front-facing seat fitted with an
automatic or static three-point
belt approved under the ECE R16
standard or similar. Do NOT use a
two-point belt.
•
After placing the child in the
child seat, ensure the harness is
sufficiently tight by pulling the
belt. Before every use, make sure
the harness is not damaged or
twisted.
•
Ensure you can fit only one finger
between the harnesses and your
child (1cm). If the space is greater
than 1 cm, tighten the harness
belt further.
•
Check to make sure the headrest
is adjusted to the proper height.
•
Ensure the straps under the
stomach are as low as possible
to support the pelvis properly.
•
Do not use the child restraint
device without the cover.
•
Do not replace the seat cover
with anything other than the
manufacturer's recommended
one because it will directly impact
the functioning of the car seat.
•
The temperature inside a vehicle
may be very high, particularly
after a long period of exposure to
the sun. We strongly recommend,
under such conditions, to cover
the car seat with a piece of
R387_TITANO_(KX 114)_Libretto_v4.indd 30
R387_TITANO_(KX 114)_Libretto_v4.indd 30
material or something equivalent
to prevent the harness fixings,
particularly the metal parts,
from overheating and burning
the child.
ATTENTION:
When using ISOFIX, fitting clips for
lower anchorage to the vehicle are
insufficient. The ISOFIX anchors are
designed for safe and easy fitting of
the child safety systems inside the
car. Not all cars have these anchors,
although they are standard on more
recent models. Consult the list of
cars on which the car seat can be
installed correctly on the website
https://giordanibaby.com/manuali/
•
In forward-facing position, the seat
must be placed on the car's rear
seat or, exceptionally, on the front
seat according to local legislation
(In France: Decree n° 91-1321 du
27-12-1991).
• Warning:
when installing the car
seat, spaces between the base of
the car seat and the vehicle seat
may appear depending on the
position of the anchorage within
the vehicle.
•
The rigid parts and the plastic
sections of a child restraint
device should be positioned and
installed so they cannot when
the vehicle is used under normal
conditions, become trapped
under a moving seat or in the
vehicle door.
•
Never modify the construction or
the materials of the car seat and
the seat belt without consulting
30
the
•
Th
effe
are
•
Alw
eve
in i
•
Ne
the
don
acc
•
Alw
sea
und
doo
•
If in
cor
use
dis
of
sys
•
Kee
use
Inser
•
The
Evo
int
sys
chi
cov
you
bel
Evo
is e
Evo
Fabr
•
The
rem
10/11/23 14:56
10/11/23 14:56
Publicidad
