Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IUsually, hedges should be cut in the shape
of a trapezium (as in the figure), that is, both
sides are gradually larger in the bottom.
This shape will expose the surface of the
hedge to sun light, which will provide a
more even growth. For reference, apply an
inclination of approximately 10 cm to a
one-meter hedge (as in the picture).
Cutting sequence:
First cut both sides, bottom up, so that small
pieces do not fall in the cutting area. After
that, cut the upper part (picture opposite).
In case of long branches, cut the hedge
several times to have better control of the
equipment and to demand less effort from
the motor - branches that are cut shorter,
decompose easier.
Table for the Correct Use of the Extension Cord
Length in meters
Voltage
Gauge (Ø) in A.W.G.
Gauge (Ø) in mm
Voltage
Gauge (Ø) en A.W.G.
Gauge (Ø) en mm
Motor
Single phase Universal 110/127 V
22
10
18
0,75
18
0,75
Technical Specifications
Type
Voltage
220/230 V
Indications
20
30
40
110 / 127 Volts
16
14
14
1,0
1,5
1,5
220 / 230 Volts
18
16
16
0,75
1,0
1,0
Power
Blade length
500 W
510 mm
10 cm
50
60
70
14
12
12
1,5
2,5
2,5
16
14
14
1,0
1,5
1,5
Maximum cutting width
16 mm
80
90
12
12
2,5
2,5
14
14
1,5
1,5
Publicidad
Tabla de contenido
