Publicidad
Idiomas disponibles
Idiomas disponibles
Ready Cycle: With the green "ready" symbol illuminated, press the cycle
start button (F).
Heat Cycle: The red symbol will indicate that the appliance is "HEATING"
to create steam. It will remain lit until all water is consumed and the
sterilization cycle is complete. This is approximately 8 minutes but may
vary by the amount of water you add, the number of items to be
sterilized and other environmental factors.
Cool Down Cycle: Upon the completion of the sterilization cycle, the
blue symbol will illuminate to indicate the "COOL DOWN" cycle. Note:
If you forget to add water to the unit and start the heating cycle (red light
on), the unit must complete the cool down cycle (blue light on) before a
new "heat" cycle can be attempted.
READY (unload) Cycle: When the cool down cycle is complete, the
green "READY" symbol will again light. You may unload your items or
allow them to air dry.
WARNING: DO NOT open lid or reach over the appliance while in use,
as steam will cause burns and serious injuries. DO NOT touch
hot surfaces, including top cover, main cover and trays, during or
immediately after use.
9
Open the main cover and remove all bottles and place on a countertop or other
flat surface. Open the top cover and re-assemble the bottles with the various
components.
CAUTION: After sterilizing, wait 10 minutes for parts to cool, then
open top cover carefully and beware of residual steam. Be careful to
avoid spilling or splashing water on yourself when removing contents.
10
You may now turn the unit off by pressing the on-off button (E) or begin another
sterilization cycle after again adding 3 oz/80 mL of water.
4
Publicidad
