Publicidad
English
CONTROLS
(Refer to the attached sheet.)
@ REVERSE MODE switch
3 Set to this position for continuous playback.
: Set to this position for both-sides Playback.
(=) : Set to this position for one-side playback.
@ DOLBY NR/FM mode switch
Set to ON when playing back a tape recorded with noise
reduction. In the CX-F5K/G, this also
functions as an FM mode switch:'set to FM ST when listening
to an FM stereo broadcast.
© (Cx-F5K/G)
Function switch (This switch is also used as the TAPE switch.)
RADIO
: Set to this position to listen to the radio.
(OFF) TAPE : Set to these positions to listen to a cassette, After use,
set to these positions
to turn off the power.
(CX-5K)
TAPE switch
When playing a CrO, or metal tape, set to Cro, /METAL.
O </P> Fast wind buttons
Press to wind the tape quickly in the direction
of the arrows.
© <> Play button
Press to listen to a cassette. Playback is first in the
forward direction (according to the setting
of the REVERSE
MODE
switch). Press again to play in the reverse direction. Each time
this
button is pressed, the tape is reversed.
@ DIRECTION/BATTERY indicator
Indicates the direction of tape travel. The battery can be checked
with the function switch set
to (OFF) TAPE,
POWER
SUPPLY
® Checking the battery
With. the function switch set to (OFF) TAPE, press the
<4
button and check the BATTERY
indicator. For the CX-5K, check the BATTERY indicator
while pressing the <p> button,
Lights brightly
CASSETTE PLAYBACK
© TAPE switch
Set according to the tape.
NORMAL
: Set to this position when using normal (Type
|) tape,
CrO, /METAL : Set to this position when using metal
(Type !V) or CrO, (Type II) tape.
® Dolby* NR system
The
Dolby
B NR system and JVC's ANRS
(Automatic
Noise Reduction System) are com-
patible,
*"Dolby" and the double-D symbol are trademarks
of Dolby Laboratories Licensing Corporation,
e FM mode switch
Normally set to FM ST. When an FM stereo broadcast is being received, the unit switches to the
stereo mode automatically. !f you are in a weak signal area, too far from the station or indoors
and there is too much noise, open the cassette holder slightly (to the first position. in which it
locks) and set the FM mode switch to MONO,
@ Note on AM reception
When a cassette with a metal shell or label is loaded, AM reception may be noisy or the frequency
may drift. if this happens, remove the cassette,
CLEANING
THE
HEAD
For optimum playback, the head, etc. must be clean. Clean the head, capstan, etc. with a cotton
bud moistened with alcohol every 10 hours or so of use.
Playback head
TROUBLESHOOTING
* Is battery exhausted?
* ls the head clean?
© Output level too low.
@ Sound quality unsatisfactory.
© AM reception unsatisfactory.
PRECAUTIONS
To prevent damage
When listening with headphones
Publicidad
