cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 151

Does not turn on
Wash cycle does not start
No water or detergent enters
the drum. Error "E02" appears
on the screen
Water discharge when the
programme starts
The water level is too low
when the machine is washing.
Appliance is not fully plugged in or not plugged in enough to
make contact.
No power is reaching the socket. Check the fuses and control
and protection elements of the electrical installation.
The door is not closed properly.
The "START/PAUSE" button has not been pressed.
The water tap has not been turned on to allow water to flow
into the appliance.
A delayed end function has been configured.
Water supply hose is kinked or bent.
The water supply hose is not connected to the water supply.
The water pressure is too low.
The water tap has not been opened to allow water to flow into
the machine.
There is no water supply in the dwelling.
The mesh filter in the water supply hose and/or the water
inlet valve is/are blocked.
Tap and/or water supply pipe is/are frozen.
The "START/PAUSE" button has not been pressed.
There is already enough water in the drum.
This is not an issue. Do not open the door to pour water
directly into the drum before the programme is run, otherwise
the machine may discharge the water that was poured into
the drum when the programme was started.
This is not an issue. The water consumption in the wash cycle
of this appliance is relatively small, the water level in the wash
cycle is lower than that of other types of washer dryers.
BOLERO WASH&DRY 10680 INVERTER B / STEEL B
ENGLISH
151