Publicidad
Idiomas disponibles
Idiomas disponibles
Ceramic fan heater column Use instructions
EN
Product description Fig.A
1. Control panel and LED display
2. Flame effect light panel
3. Heating elements and protection grid
4. ON/OFF switch (at rear)
5. Base
Assembly Fig. B
Remove all packaging material and check the integrity of the unit and power cable. Keep packaging material
out of the reach of children.
To assemble the base, join the two semicircular halves following the grooves visible on the flat side; with the
appliance upside down, position the base by sliding the power cable through the central hole, and secure it
to the appliance with 4 ST3x8 screws (supplied).
After securing the base, slide the power cable through the small hole on the side. Make sure that the base is
correctly installed, and that the unit is stable before putting it into operation.
Operation from the control panel Fig.C
Place the device on a dry and stable surface. Connect the device to the power socket; set the ON/OFF switch
(on the back) to "I", the LED display lights up and the device enters stand-by mode.
On the control panel, press
and the ambient temperature is displayed.
Press
to activate ventilation mode and the
lights up. Press
again to select the lowest heating intensity
(the
symbol lights up on the display), press the button again to select the highest heating intensity (the
symbol is shown on the display).
To select the desired temperature, press the
button: the display will show the operating temperature; press
the button until the desired temperature is shown; temperatures from 18°C to 45°C can be selected. After a
few seconds, the display stops flashing, and the temperature selection is confirmed.
To activate the horizontal oscillation, press the
button; press it again to deactivate the function.
To set the automatic switch-off timer, press the
button: the display shows the setting 0H; press the button
until the display shows the desired option (0H to 8H); once the display stops flashing, the selection is confir-
med, and the timer is set.
To switch on the flame effect, press the
button; press it again to switch off. The flame effect can be
switched on even if the ventilation and heating functions are not active.
To switch off the appliance, press the
: the fan will continue to run for 30 seconds so that the appliance
cools down. Once cooling is complete the stove will stop running (the countdown is shown on the display).
Never interrupt the cooling phase. When it has finished, set the ON/OFF switch at the rear to "O".
The appliance is equipped with an automatic system that regulates the heating intensity according to the
ambient temperature:
If the selected temperature is equal to or lower than the detected room temperature, the unit stops heating,
continuing to operate in ventilation mode.
If the selected temperature is 1-2°C higher than the detected room temperature, the unit operates with low
heating intensity.
If the selected temperature is at least 3°C higher than the detected room temperature, the device operates
at high heating intensity.
The appliance is also equipped with a safety sensor in the base, which automatically interrupts operation of
the appliance in the event of a fall or tip-over.
Use from the remote control Fig.D
Remove the protective film to activate the battery.
All functions that can be selected from the control panel can also be activated from the remote control, please
refer to the section "Operation from the control panel".
To set the temperature from the remote control, press the
button, and then select the desired temperature
using the + and - buttons.
Cleaning and Maintenance
Make sure that the switch on the back is set to 'O' and that the appliance is unplugged from the power socket
before carrying out any cleaning and maintenance work.
Caution: Do not immerse the device in water or other liquids.
13
Publicidad
