Descargar Imprimir esta página

Frigidaire GALLERY GHWQ085WD101 Uso Y Cuidados página 13

Aire acondicionado

Publicidad

FCC Interference Statement
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These
limits
are
reasonable
protection
interference in a residential environment.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television
reception,
determined by tuning the device o
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device
and receiver.
• Connect the equipment into an outlet other
than the one used for the receiver.
• Consult the dealer or an experienced
radio/TV technician for assistance.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) This device
must accept any interference received,
including
interference
undesired operation.
FCC
CAUTION:
modifications not expressly approved by the
party responsible for compliance could void
the
user's
authority
equipment.
Host device Labeling
This device includes the following module.
Contains FCC ID: 2AIBX-NIULL
RF exposure statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be
installed and operated with minimum 20 cm
between the radiator and your body. This
transmitter must not be collocated or
operating in conjunction with any other
designed
to
provide
against
harmful
which
can
and on,
that
may
cause
Any
changes
to
operate
FCC STATEMENT
antenna or transmitter unless authorized to
do so by the FCC.
INDUSTRY CANADA (IC) STATEMENT
This Class B digital apparatus complies with
Canadian ICES-003.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1)
this device may not cause interference, and
(2) this device must accept any interference,
including
interference
undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
be
autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si
le
brouillage
compromettre le fonctionnement.
RF Exposure
The antenna (or antennas) must be installed
so as to maintain at all times a distance
minimum of at least 20 cm between the
radiation
source
individual. This device may not be installed or
used in conjunction with any other antenna
or transmitter.
l'exposition aux RF
L'antenne (ou les antennes) doit être installé
e de façon à maintenir à tout instant une
distance minimum de au moins 20 cm entre
la source de radiation (l'antenne) et toute
personne physique.
or
Host device Labeling
This device includes the following module.
Contains IC: 21700-NIULL
the
Host dispositif d'étiquetage
Ce dispositif inclut le module suivant.
Contient module émetteur IC: 21700-NIULL
13
that
may
est
susceptible
(antenna)
and
FCC module location
cause
d'en
any

Publicidad

loading