Change User Code; Change Admin Code - Smanos WK8000 Manual De Funcionamiento

EN

Change User Code

Using user code can wake up keypad, or send Arm, Disarm, Stay
Mode commands to the control panel.
Change User Code
Enter setup state, input:
When one beep is heard and the LED indicator keeps on for
10 seconds, the setup is successful.
Note: User code is 4 digits; default code is "1234".
17
8 new user code

Change Admin Code

Using admin code can wake up keypad, send Arm, Disarm, Stay
Mode commands to the control panel, and also change keypad
settings.
For your safety, it is suggested to change both user codes and
admin codes after your purchase.
Change Admin Code
Enter setup state, input:
9 new admin code
When one beep is heard and the LED indicator keeps on for
10 seconds, the setup is successful.
Note: Admin code is 6 digits; default code is "123456".
EN
18