Descargar Imprimir esta página

Iluminarc LOGIC POE Injector Guía De Referencia Rápida página 2

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the LΩGIC POE Injector.
The product is intended for professional use only.
CAUTION:
This product's housing may be hot when operating. Mount this product in a location with adequate
ventilation, at least 20 in (50 cm) from adjacent surfaces.
When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid
ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure,
allow the product to fully acclimate to the surrounding environment before connecting it to power.
ALWAYS:
Disconnect from power before cleaning the product.
Connect this product to a grounded and protected circuit.
DO NOT:
Open this product. It contains no user-serviceable parts.
Leave any flammable material within 20 cm of this product while operating or connected to power.
Connect this product to a dimmer or rheostat.
Operate this product if the housing or cables appear damaged.
Operate this product outdoors or in any location where dust, excessive heat, water, or humidity may affect
it. (IP20)
The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
In the event of a serious operating problem, stop using immediately.
FCC Statement of Compliance
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
What is Included
LΩGIC POE Injector
Seetronic Powerkon IP65 power cable
AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
1
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Quick Reference Guide
Wire (Europe)
Brown
Blue
Green/Yellow
LΩGIC POE Injector QRG Rev. 1
Screw Color
Yellow/Brass
Silver
Green

Publicidad

loading