Publicidad
Idiomas disponibles
Idiomas disponibles
How to Start:
1.
Set the On/Off switch to "On"
and allow tank pressure to build.
Motor will stop when tank pressure
reaches "cut-out" pressure.
2.
Turn regulator knob clockwise to
increase pressure and stop when
desired pressure is reached.
lf any unusual
noise or vibration
is noticed, stop the compressor
immediately and have it checked
by
a trained
service technician.
The compressor is ready for use.
Customer
Responsibilities
Before
each
use
Check Safety Valve
X
Drain Tank
_Unit
cycles
--
automatically
when
power is on. When performing
maintenance,
you may be exposed
to voltage sources,
compressed
air,
or moving parts. Personal injuries
can occur. Before performing any
maintenance
or repair, disconnect
power source from the compressor
and bleed off all air pressure.
NOTE: See Operation section for the
location of controls.
Daily
or after
each
use
X
To Drain Tank
Risk of Unsafe
Operation.
Risk
from noise. Air tanks contain high
pressure air. Keep face and other
body parts away from outlet of
drain. Use ANSI Z87.1 eye protection
(CAN/OSA Z94.3) when draining
as
debris can be kicked up into face.
Use ear protection
[(ANSI S12.6
($3.19)] hearing protection)
as air
flow noise is loud when draining.
To Check
Safety
Valve
_Risk
of Bursting.
--
if the safety valve
does not work properly, over=
pressurization
may occur, causing
air tank rupture or an explosion.
_Risk
from Flying
__
Objects.
Always
wear certified safety equipment:
ANSI Z87.1 eye protection
(CAN/OSA
Z94.3) with side shields
1.
Before starting compressor, pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve
is stuck or does not operate
smoothly, it must be replaced with
the same type of valve.
1.
Set the On/Off switch to "Off".
2.
Turn the regulator knob counter-
clockwise to set the outlet
pressure to zero.
3.
Remove the air tool or accessory.
4.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 PSI. Release safety valve ring.
5.
Drain water from air tank by
opening drain valve on bottom of
tank.
Risk of Bursting.
Water will condense
in the air tank. If not drained, water
will corrode and weaken the air tank
causing
a risk of air tank rupture.
N014212
14 - ENG
Publicidad
