Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the temperature may
u
exceed 40°C.
Charge only at ambient temperatures between 10°C and
u
40°C.
Charge only using the charger provided with the appli-
u
ance/tool. Using the wrong charger could result in an
electric shock or overheating of the battery.
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Do not damage/deform the battery pack either by puncture
u
or impact, as this may create a risk of injury and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe the
liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions below
Warning! The battery fluid may cause personal
injury or damage to property. In case of skin contact,
immediately rinse with water. If redness, pain or ir-
ritation occurs seek medical attention. In case of eye
contact, rinse immediately with clean water and seek
medical attention.
Chargers
Warning! Your charger has been designed for a specific
voltage. Always check that the mains voltage corresponds to
the voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your STANLEY FATMAX charger only to charge the
u
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
u
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised STANLEY FATMAXService
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The charger must be placed in a well ventilated area when
u
charging.
Labels on the charger
The following symbols are found on your charger:
12
(Original instructions)
The charger is intended for indoor use only.
Read the instruction manual before use.
Electrical safety
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised STANLEY FATMAX
Service Centre in order to avoid a hazard.
Features
1.
ON/OFF trigger switch
2.
Lock-off lever
3.
Chain brake / front hand guard
4.
Guide bar
.
5.
Saw chain
6.
Sprocket cover
7.
Bar lock nut
8.
Chain tensioning screw
9.
Oil cap
10. Oil level indicator
11. Guide bar scabbard
12. Rear handle
13. Front handle
14. Battery pack
15. Battery pack release button
16. Hex wrench
17. Hex wrench storage
Assembly
Warning! Before assembly, remove the battery (14) from the
tool.
Charging the battery (Fig. A)
The battery needs to be charged before first use and whenev-
er it fails to produce sufficient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell tempera-
ture is below approximately 10 °C or above 40 °C.
Publicidad
