cecotec IRONHERO 3200 I-PUMP ANODIZED Manual De Instrucciones página 7

SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the product.
Keep this instruction manual for future reference or new users.
- Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is grounded.
- Do not leave the iron unattended while hot, plugged in, or on
an ironing board.
- Place the device on a flat, even, and heat-resistant surface.
- CAUTION: hot surface. Accessible surfaces may
reach high temperatures during operation.
- Do not operate the appliance if it has been
dropped, if it shows visible signs of damage, or if it leaks.
- Do not pull on the power cord when unplugging or moving
the device, pull on the plug instead.
- Do not twist, bend, pull, or damage the power cord. Protect it
from sharp edges and heat sources. Do not allow it to touch
hot surfaces. Do not let the cord hang over the edge of the
working surface or worktop.
- Do not immerse the cord, plug, or any non-removable part
of the appliance in water or any other liquid, nor expose
electrical connections to water. Make sure your hands are
dry before handling the plug or switching on the appliance.
- Check the power cord regularly for visible damage. If the
cord is damaged, it must be repaired by the official Technical
Support Service of Cecotec to avoid any type of danger.
- Avoid contact with the steam generated by the iron. Steam
temperature is very high and can cause burns and other
damage.
- Disconnect the iron from the power supply when filling or
IRONHERO 3200 I-PUMP ANODIZED
7