ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1.
Lid
2.
Desiccant bag
3.
Desiccant compartment
Food tank
4.
5.
Closing of the tank
6.
Main body
7.
Camera
Display
8.
9.
Dispensing outlet
10. Stainless steel bowl
11. Plastic bowl bracket
Display Fig. 2
1.
Indicator light
2.
Microphone icon
Wi-Fi reset icon
3.
4.
Food dispensing icon
Please note
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
-
Pet feeder
42
PUMBA 6000 PURRFECT MEAL SMART VISION
-
USB cable
-
Adapter
-
Safety lock
-
Desiccant bag
-
Stainless-steel bowl
-
Instruction manual
3. PRODUCT ASSEMBLY
Plug the appliance into a power supply. Fig. 3
-
Plug in the 5 V adapter and connect the power cable to the feeder. (2)
-
Open the battery compartment at the bottom of the device (1) and install 4 AA alkaline
batteries (not included) as an alternative in case of power failure or failure of the power
supply (3).
-
The display will automatically light up indicating that the feeder is on (4).
-
Install the food tank following the steps below: Fig. 4 (5)
-
Take into account the direction of the food dispensing elements. Fig. 5
-
The food inlet must be in the same direction as the dispensing outlet. Fig 4.
Adding pet food into the tank. Fig. 6
Fill the food tank with pet food. Place the lid on the food tank and install the safety lock. Fig. 9
Please note
-
Do not use canned or wet food.
-
Recommended food size: 5-10 mm. Fig. 7
Installing the food bowl:
-
Align the plastic bracket with the holes in the base, and push upwards to join them. Fig. 8
-
Place the stainless steel bowl inside the plastic bracket. Fig. 9
ENGLISH
PUMBA 6000 PURRFECT MEAL SMART VISION
43