Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1 Support bolts
2 Support bolt pads
3 Sliding arm
MOUNTING
1. Set initial adjustment with the support frame on the floor under the vehicle before lifting into
position. Initially set engine/transmission support plate (7) low to assist fitting.
2. The support hooks (6) are hooked over the main engine/transmission support crossmember,
either over the edge of the crossmember or through convenient access holes. Slide hooks (6)
along frame to desired position then secure by tightening fixing screws (5). Hooks can then be
adjusted up or down to attach to crossmember, then secured when in the correct position.
3. Support bolts (1) can be mounted in two positions in the cross bar (9) and the cross bar can be
mounted in two position in the sliding arm (3), offering maximum flexibility in choice of location.
The weight of the engine or transmission being supported is transferred across the frame to the
support bolts, thus position the support bolts by choosing strong, supported areas of the floorpan,
bulkhead or transmission tunnel, to bear this weight.
4. Then adjust the engine/transmission support plate (7) up onto a suitable area on the engine or
transmission being supported. The support plate (7) can be adjusted by wing nut (8) once work is
underway, for example when replacing an engine mounting.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
4 Tensioning nuts
5 Fixing screws
6 Support hooks
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
7 Support plate
8 Wing nut
9 Crossbar
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
