Thermaltake Toughpower 700W Manual Del Usuario página 4

Toughpower
TM
3. Power Connector Introduction
Cable
P/N Model 20+4pin Main 4pin +12V CPU 8pin +12V CPU
Connector Connector Connector
W0295 700W 1 1 1
W0296 800W 1 1 1
Connector Type
20+4pin
ATX 12V 4pin
MODELS
EPS 12V 8pin
700W
800W
Molex & FDD
SATA
PCI-E 8/6pin
03
700W / 800W
SATA Peripheral Floppy 8pin PCI-E 6pin PCI-E
Connector Connector Connector Connector Connector
6 5 1 2 2
6 5 1 2 2
Connectors & Cable length
1 x 20+4pin Main connector
(500mm)
1 x ATX 12V 4pin connector
(500mm)
1 x EPS 12V 8pin connector
(500mm)
2 x Peripheral & 1 x FDD connectors
(500mm + 150mm + 150mm)
3 x Peripheral connectors
(500mm + 150mm + 150mm)
3 x S-ATA connectors
(500mm + 150mm + 150mm)
3 x S-ATA connectors
(500mm + 150mm + 150mm)
1 x 8/6pin PCI-E connectors
(500mm + 150mm)
1 x 8/6pin PCI-E connectors
(500mm + 150mm)
Toughpower
4. Installation Steps
Note: Make sure that your system is turned off and unplugged.
Disconnect the AC power cord from your old power supply.
PCI-E (8 to 6)
Connector
2
1. Open your computer case; please refer to the direction in your
2
case manual.
2. Install the PSU into the case with the four screws provided.
3. Connect the 24 pin Main Power Connector to your motherboard
and peripheral. If your motherboard uses a 20-pin
connector, detach the 4-pin attachment on the 24-pin connector.
Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V
connector.
4. Connect the 8-pin or 4-pin connector for the CPUs.
5. Connect other peripheral power connectors to devices such as
hard drives, optical
6. Close your computer case and connect the AC power cord to
the power supply AC inlet.
TM
700W / 800W
drives, etc.
04