universalblue UBF2229-23 Manual De Instrucciones página 38

ENGLISH
within the acceptable temperature ranges.
If an appliance with climate class SN is
operating at a colder temperature, there
will be no damage until the temperature
reaches 5ºC
UniversalBlue recommends
the refrigerator in a space where the
temperature ranges from 16ºC to 38ºC
Stacked installation or side by side. If you
want to install two refrigerators, one on top
of the other or one next to the other, there
must be at least 150mm between them.
The Refrigerator must be installed on a
completely flat surface; leave between 5
and 10 cm on both sides of the appliance,
7,5 cm between the back part and the
wall and 10 cm between the top part of
the appliance and the ceiling. A wrong
positioning could lead to increasing the
noise level.
It is possible to install certain appliances
without a minimum distance. Check with
an authorized dealer or kitchen designer.
Reversible doors
The side for which the fridge door opens
can be altered from the right to the left side,
should your installation site require it.
Follow the instructions below to make the
change (see picture sequence in picture 03
on page 5):
• Remove the top hinge (A and B) cover.
• Lift the freezer door to disengage it from
the center hinge, set the door aside and
gently place it on a cushioned surface.
• Using a screwdriver, disassemble the
center hinge; lift the fridge door to
disengage it from the bottom hinge (C).
Set the door aside and place it gently on
a cushioned surface.
• Pull out the hinge pin, rotate it 180
degrees, reverse and reinstall it on the
opposite side. Shift over the position of
the bottom hinge and adjustable leg to
the other side of the cabinet.
• Remove the hinge pin located on the
38
bottom of the fridge and freezer door.
On the other side of the fridge (D) and
freezer (E) door, insert the replacement
hinge
appliance into the bag of parts (F y G).
• Place the fridge door on the bottom
to install hinge, making sure the hinge pin is
inserted into the hole in the bottom of
the freezer door. Place the center hinge
back into the cabinet, making sure it is
on the opposite side from the original
position.
• Place the freezer door on the center
hinge, making sure the hinge pin is
inserted into the hole in the bottom of
the fridge door. Place the top hinge on
the fridge door, securing the screw and
cover.
• Remove the top hinge from the fridge
door, rotate the top hinge 180 degrees,
remove the hinge pin, reverse and
reinstall it on the opposite side.
• Remove the left top hinge cover parts
from the bag, install them on the left
side, and tighten all screws.
USING THE APPLIANCE
Before the first use
Before using the appliance, remove all
packaging, including corks and rubber
straps. Adjust the legs and clean the
exterior and interior of the fridge with a
warm cloth. Do not start the appliance
immediately after installation. It should
be started after the appliance has been
standing for 2 to 6 hours to ensure its
proper operation.
To prevent damage to the power cable and
any resulting incidents, it must be well
protected.
Before turning it on, please check if the
voltage range of the fridge is the same as
that of the power supply. When the fridge
is first installed, allow it to become stable
at normal operating temperatures for 2-3
hours before filling it with fresh or frozen
food. If the operation is interrupted, wait 5
screw supplied with the