Hailo S120 Pro Instrucciones De Uso página 25

The rung-step rotary modules can be converted into
a ladder step or a ladder rung.
• Position „A" = ladder rung
(use of the rung as a transport route)
• Position „B" = ladder step
(use of the step as a workstation)
Operation of the locking element [I]:
1. Press both release buttons [I-1], the „RED"
display [I-3] is visible, the rung-step rotary
module [H] is unlocked and can be pivoted.
2. Rotate the rung-step module to the position of
the ladder step, the rotary module automatically
locks in. The „GREEN" display [I-2] is visible,
the rotary module [H] is locked and can be
climbed.
To turn the rung-step rotary module back into the
original position, proceed in the same manner.
WARNING
Risk of injury!
Only climb the ladder when the rung-step rotary
module is securely locked. The locking guide
„GREEN" [I-2] must be fully visible.
7.5 Set-up and use as a stepladder
1. Place the ladder on the ground and raise it until
it is vertical. Unlock the extension ladder [J],
position it one or two rungs higher and lock it
again.
2. Unlock the extension section [B] of the steplad-
der [A] at the lock hook [E] and unhinge, pulling
forward and thereby opening the stepladder
completely.
3. The tensioning strap [F] must be completely
taut. The ladder side rail of the extension
section [B] must be in a locked position at the
guide bracket of the stepladder [A].
4. Unlock the extension ladder [J] on the locking
hook [E] and push it into the desired position
on the ladder guide. Then securely lock it to the
ladder rung again.
7.4
„A"
2.
7.5
„B"
en
25