Descargar Imprimir esta página

VEVOR BL350-19 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65
2.3 Brake:
When tightening the front and rear wheel handles, the front and rear wheels can
be brake respectively.(Left is the rear brake, right is the front brake)
2.4 Parking:
A. Should use the turn signal in advance to signal, inform other vehicles,
pedestrians to attract attention, and then gradually drive to the roadside;
B. Turn the speed control knob back, hold the front and rear brake knob, then the
brake light is on, inform the pedestrian or vehicle behind;
C. After the car is completely stopped, turn off the turn signal light and put the key
switch to the OFF position;
D.support a single or double support, but do not park the car on the soft or sloping
ground to prevent the vehicle from slanting;
Lock the steering handle: turn the handlebars to the left; insert the key from the
lock OFF, press the key and turn the key to the LOCK position.
Note:when locking the handlebars,if the handlebars cannot be locked,it means
that the handlebars do not turn in place.at this time,the handlebars should be
slightly moved from side to side,and the key can be turned at the same time.
F. Electric vehicles should avoid being placed in places with humid air, humidity is
too high, and corrosive gas, so as not to cause chemical corrosion on the surface
of electroplating paint on the metal parts and plastic parts of electric vehicles;
G. electric vehicles should avoid exposure to the hot sun and rain for a long time to
avoid damage to the components in the controller, resulting in accidents other than
operation failure.
H. If the single support power switch is damaged, it must be replaced in time to
avoid damage.
3. Common Faults And Troubleshooting
Common fault
Turn on the power supply,
but the instrument does not
display;
Turn the speed regulator,
the motor does not work.
Turn on the power supply,
and the instrument appears
normal;
Turn the speed regulator,
the motor does not work.
The exclusion method
1. Check whether the storage battery is well
connected;
2. Check whether the air switch is tripped;
3. Check whether the electric door lock fails;
4. Otherwise, it may be regarded as a partial
failure of the controller.
1. Check whether the speed control handle and
motor connection fall off;
2. whether the left and right brake is in the state
of power failure;
3. Otherwise, it may be regarded as a partial
- 9 -

Publicidad

loading