Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL
MOWER
HOUSING
Adjust
the
mower
while
riding
mower
is
parked
on level
ground
or driveway.
Make
sure
tires
are
properly
inflated
(See
side
of tire for proper
PSI).
If tires are over or
underinflated,
you
will
not properly
adjust
your
mower.
SIDE-TO-SIDE
ADJUSTMENT
• Raise
mower
to its highest
position.
• Measure
distance
"A" from bottom
edge
of mower
to ground
level at front corners
of mower.
• To raise the right side ofthe mower, tighten
lift link adjustment
nut.
• To Iowerthe
right side ofthe mower, loosen
lift link adjustment
nut.
NOTE:
Each full turn of adjustment
nut will
change
mower
height
about
3/16".
Bottom Edge of
Bottom Edge of
Mower to Ground
Mower to Ground
A;L !! il
If !ILJ
• Recheck
measurements
after adjusting.
FRONT-TO-BACK
ADJUSTMENT
iMPORTANT:
Deck
must
be level
side-to
side.
To obtain the best cutting
results,
the mower
housing
should
be adjusted
so that the front is
approximately
1/8" to 1/2" lower than the rear
when
the mower
is in its highest
position.
Check
adjustment
on right
side
of riding
mower.
Measure
distance"F"
directly
in front
and behind
the mandrel
at bottom
edge
of
mower
housing
as shown.
• To lower front of mower
housing
turn nuts
"G" and "H" clockwise.
• When
distance
"F" is 1/8" to 1/2" lower
at front than
rear, tighten
nut "H" against
trunnion
on front
link.
• To raise front of mower
housing
turn nuts
"G" and "H" counter
clockwise.
• When
distance
"F" is 1/8" to 1/2" lower
at front than
rear, tighten
nut "H" against
trunnion
on front
link.
NOTE:
Each full turn of "G" will change
"F"
by approximately
about
3/8".
• Recheck
side-to-side
adjustment.
21
Nut "G"
TO REPLACE
MOWER
BLADE
DRIVE
BELT
MOWER
DRIVE
BELT REMOVAL
1.
Park riding
mower
on a level surface.
2.
Set parking
brake.
3.
Lower
mower
to its lowest
position.
4.
Remove
mandrel
cover
from
mower
deck.
5.
Remove
rear engine
plate from
unit.
6.
Remove
rear belt keeper
from unit.
7.
Carefully
roll belt
over
the
top
of the
mower
blade
mandrel.
8.
Remove
belt from idler pulleys.
Mower Drive Belt
Keeper
Idler Pulleys
9.
Check
idler pulleys to see that they rotate
freely.
10. Remove
belt from rear drive
pulley.
MOWER
DRIVE
BELT INSTALLATION
Install
in reverse
order
following
instruc-
tions in "MOWER
DRIVE
BELT REMOVAL"
section.
Publicidad
