Bresser NATIONAL GEOGRAPHIC 9070300 Manual De Instrucciones página 27

7. Push the CH button to set the desired transmission
channel (setting CH1, CH2, CH3 or channel cycle) (on
screen display).
8. Push the °C/°F button to set the desired temperature
format (setting °C or °F on screen display).
9. Replace the battery compartment cover.
9 Connecting remote sensors
The weather station can display the readings from up to 3
wireless sensors* of the same type. Each wireless sensor
must be set to a separate channel. Proceed as follows to set
the channel.
1. Remove the battery compartment cover of the wireless
sensor.
2. Slide the channel selection slide switch to the position
for the desired channel (1, 2 or 3). If only one sensor is
used, we recommend channel 1.
3. Re-attach the battery compartment cover.
4. Press the [CH] button on the base station several times
to display the measured values for the individual chan-
nels. The selected channel is shown in the display.
5. Press [CH] button for about 3 seconds to reset the val-
ues and search for a wireless sensor (RF signal).
*one wireless sensor included, more optionally available
10 Automatic time setting
After the power has been restored, the unit automatically
searches for the radio signal. It takes approximately 3-8
minutes for this process to be completed.
If the radio signal is received correctly, the date and time
are set automatically and the reception symbol is displayed.
If no radio signal has been received, proceed as follows:
27 / 100