Publicidad
The start and stop button was pressed when the butto
hole stitch (Stitch No.1) is NOT selected and with the
buttonhole lever DOWN.
I Connect the foot control plugs correctly.
2 Do riot press the start and stop button when the
machine is connected to the foot control.
1 The foot control has been disconnected during the
sewing.
2 The start and stop button was pressed when the foot
control is connected to the sewing machine.
Set the correct stitch length
1 Stitch width is not set at
114fl
when stretch stitches
(Stitch No.11-20) are selected.
2 Stitch width is set to
H4
when Stitch No.1 or stitch
No.3-10 are selected.
7. ERROR MESSAGES AND BEEP SOIJNDS
The help window LCD displays error messages when the machine is
not operated correctly.
When the following messages are displayed, correct the problems
with the following sotutions.
Flashing
______
display
________
(with beep
sounds)
Solution
Possible
cause
Lower the presser foot lift
The start and stop button (or reverse stitch lever) was
pressed when the presser foot lift is UP.
S I
Pull down the buttonhole lever and push it to the bacl
-DL
°'"°untHftclicks,
!
1i
.
The start and stop button was pressed when the butto
Possible
hole stitch (Stitch No.1) is selected and with the button
[
[
cause
hole lever UP.
Raise the buttonhole lever UP.
a
-
Solution
Move the bobbin winder shaft to the right.
••
>
Possible
The bobbin winder shaft returned to the left when wind
J
cause
the bobbin.
*
Solution
Possible
cause
Flashing
display
(no beep
sound)
Set the correct stitch width (except UOH)
Stitch width is set to
when the stitch patterns select
KIflT ctrinht
tith (Stitnh Mn 2 nnr strniaht
stretc
Publicidad
