Important - Polygroup SUMMER WAVES Serie Manual Del Usuario

8. Start with one side of the pool. Insert two U-shaped Pipes, through the rectangular flaps, into the holes on the Horizontal Beam Assembly as in Fig. 3. To secure
each end of the pipes, press down the lock buttons of the U-shaped Pipe Cap (see DETAIL 3A), and push the entire cap into the hole until it locks in place.
9. Repeat for the other side of the pool.
DETAIL 3A
Press In
10. Inflate the top ring. Squeeze the base of the valve stem to open an internal check valve while inflating.
11. IMPORTANT: PLEASE COMPLETELY INSTALL YOUR FILTER SYSTEM FIRST BEFORE PUTTING
ANY WATER IN YOUR POOL. Follow the "Setup Instructions" in the Filter Pump System Owner's
Manual and install the entire Filter Pump System first. Plug both Pool Wall Fittings from the inside of the
pool. Make sure the liner drain fitting is plugged securely and the cap is in place.
12. Start filling the pool with water. After about 1 inch of water is on the bottom, stop filling and smooth all
of the wrinkles out of the bottom of the pool.
13. IMPORTANT: IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE
POOL STARTS FILLING IN THE CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE
CORRECTED. YOU MAY NEED TO START OVER. SEE PAGE 8 WARNINGS IN THIS MANUAL.
FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE MAY CAUSE THE POOL TO COLLAPSE AND
WILL VOID THE WARRANTY!
NOTE: THE WEIGHT OF THE WATER WILL PREVENT ANY ADJUSTMENT AFTER THIS POINT.
14. Now, as you continue filling, the inflated ring will rise as the water deepens. Pull the outer wall out from
under the top ring, check all around the bottom of the pool to make sure it fills evenly. The maximum water
level is the bottom seam of the inflatable ring, this information is printed on the ring. Once finished filling, refer
back to the "Swimming Pool Filter System" owner's manual, and continue through the rest of the installation.
Return
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
Horizontal Beam Assembly
Rectangular Flap
at the bottom of pool
Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
Deflated Top Ring Sleeve
1
FIG. 3
1
Intake
U-shaped Pipe Caps inserted,
through the holes of sleeve, into
the holes on the Horizontal
Beam Assembly
U-shaped Pipe inserted through
the Rectangular Flap

IMPORTANT

PLEASE COMPLETELY INSTALL YOUR
FILTER SYSTEM FIRST BEFORE
PUTTING ANY WATER IN YOUR POOL
REFER TO THE FILTER PUMP
SYSTEM OWNER'S MANUAL.
FOLLOW THE
"SETUP INSTRUCTIONS"
IN THE FILTER PUMP SYSTEM
OWNER'S MANUAL TO INSTALL THE
POWER FILTER AND THE POOL WALL
FITTINGS.
9