Publicidad
Idiomas disponibles
Idiomas disponibles
•
Use recommended
accessories (refer to page 13).
Use of improper accessories
may cause risk of
injury to persons.
•
Handle workpiece correctly. Protect hands from pos-
sible injury.
•
Turn machine off if it jams. Blade jams when it digs
too deeply into workpiece. (Motor force keeps it
stuck in the work.)
•
Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
•
Feed work into blade or cutter against direction of
rotation.
CAUTION:
Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING:
Do not attempt to operate tool until it is
completely assembled according to the instructions.
Refer to Figure 1 below.
Check for shipping damage. If damage has occurred, a
claim must be filed with carrier. Check for complete-
ness. Immediately report missing parts to dealer.
The jointer/planer is shipped complete in one carton.
Additional parts which need to be fastened to
jointer/planer
should be located and accounted for
before assembling.
A
Jointer
B
Fence Assembly
C
Push Blocks (2)
Hardware bag includes:
•
5-0.8 x 10mm Socket Head Bolts (4)
•
5mm Lock washer (4)
•
Locking Handle (2)
•
Mounting Bracket (4)
Secure fence in position with locking handles (B).
B
Figure 2 - Attach Fence Assembly
The jointer/planer weighs approximately 40 Ibs. when
completely assembled. The jointer/planer
must be
installed in a place with ample lighting and correct
power supply. To install jointer/planter:
•
Make sure there is plenty of room for moving the
workpiece through the entire cut. There must be
enough room that neither the operators nor the
bystanders will have to stand in line with the wood
while using the tool.
•
Jointer/planer can be installed on workbench using
bolts, lock washers and hex nuts (not supplied) or
using wood screws (not supplied). See Figure 3.
Jointer Base
Mounting Bracket
Figure 3 - Use Mounting Brackets to Secure Jointer
•
The jointer/planer must be bolted to a firm, level surface.
•
Make sure the jointer/planer does not rock and the
tables are level.
%
Figure 1 - Unpacking
Refer to Figure 2.
ATTACH FENCE ASSEMBLY
•
Attach fence assembly to jointer bed assembly using
four socket head bolts and lock washers (A).
-16W'
Figure 4 - Jointer/Planer Foot Print
POWER
SOURCE
WARNING:
Do not connect jointer/planer to the power
source until all assembly steps have been completed.
3
Publicidad
