Publicidad
Idiomas disponibles
Idiomas disponibles
•
Continue feeding while placing the leading hand
behind the trailing hand until the entire length of the
board is cut
•
Feed with the grain whenever possible
•
If the nature of the workpiece is such that it must be fed
against the grain, take very light cuts and feed slowly
Rotation
_in
Rotation
Figure 16 - Direction of Feed
When using long workpieces, to avoid injury from slips
or kickbacks and to exert even pressure on the cutter-
head, use extra supports (see Recommended
Accessories, page 13) at both infeed and outfeed ends
USING HOLD DOWN/PUSH
BLOCKS
Refer to Figure 17.
•
Always use hold-down/push-blocks
when jointing, or
rabbeting wood that is narrower than 3", planing
wood thinner than 3"
Figure 17 - Feeding with Push Blocks
•
Grasp the hold-down/push-blocks
firmly
•
Position the push-blocks flat on top of workpiece and
push the workpiece down against the table
•
Use a hand-over-hand
motion to maintain control
over the workpiece at all times
•
When planing workpiece between 1/2 - 3/4"and nar-
rower than the push-blocks, tilt the push-blocks so
that it clears the cutterhead guard while feeding
BEVELING
AND CHAMFERING
Refer to Figure 18
•
The fence on the jointer/planer
is adjustable to 45 °
outward Adjust the fence to the desired angle and
tighten fence lock knobs
•
Beveling refers to cutting the entire edge of a board
at an angle Beveling may require several passes
due to the depth of cut needed
•
Chamfering refers to removing only the corner of the
edge of a board Normally a chamfer is made on one
pass; so a 1/1_" depth of cut is made
Bevel Edge
Chamfer Edge
Figure 18 - Beveling and Chamfering
USING A VACUUM
HOSE
A standard dust collection hose can be attached to the
exhaust port on the rear of the jointer Jointer will per-
form properly at all depths of cuts up to %4" when used
with a dust collecting system To attach a dust collecting
system:
•
Insert the dust collection hose to the exhaust port on
the rear of the jointer
•
Turn the dust collecting system on
•
Turn the jointer on
•
Periodically replace/empty
bag in the dust collecting
system
WARNING:
Turn the switch to "Off" position and
unplug jointer/planer from power source before pro-
ceeding to do maintenance work
CHECKING
FOR WORN BLADES
Condition of blades will affect precision of cut. If blade
wear is not observed when checking the blade height,
the quality of cut will indicate the blade condition. Dull
blades will tear rather than sever wood fiber. A raised
grain will occur when dull blades pound on wood where
there is difference in density A raised ridge will be pro-
duced where the blades have been nicked
SHARPENING
BLADES
The blades can be honed individually by whetting them
with a fine sharpening stone Make sure oilstone is flat
and is not worn To sharpen blades:
•
Partially cover the stone with paper to protect the
table top
•
Position infeed table so stone will contact blade
along its beveled surface
•
Stroke the stone across blade from one side to other
while stone is also moved slightly in the direction of
feed
•
Make sure to do the same number of strokes on
each blade
8
Publicidad
