Masterpro ROCKET DUO 900 Manual De Instrucciones página 7

EN
10. SYNC FINISH
• Both baskets were set on 2 different settings. It will program to
automatically finish and be ready at the same time.
INTRODUCTION
The air fryer provides an easy and healthier way of cooking your
favorite foods. By applying rapid air circulation from all directions
additional to a top grill, it is able to cook a variety of dishes without
adding any oil or adding just a little oil to specific ingredients in the
table shown in this booklet.
BEFORE USING AIR FRYER
1. Remove all the packing materials including any in the pan.
2. Slide out the pans, take out the drip trays by straightly pulling up.
Clean pans and drip trays with a non-abrasive sponge, with hot water
and dish washing liquid. Rinse with clean water and set aside to dry.
3. Wipe clean the inside and outside of the appliance with a moist
soft cloth.
4. Place the appliance on a stable, horizontal, flat and heat resistant
surface.
IMPORTANT! Place the appliance on a heat-resistant surface only.
Not recommended to use directly on laminated / vinyl bench top. To
prevent heat damage to surface underneath, placing the air fryer on
an insulated heat pad is recommended.
COOKING WITH YOUR AIR FRYER
1. Connect the supply cord plug into a mains power outlet socket.
The appliance is now in standby mode.
2. Place the ingredients into the pans.
3. Slide the pans back into the appliance.
CAUTION! Do not touch the pans during use or immediately after
use, as the pans gets very hot during and after cooking. Only hold
12
by the handle.
4. Touch the power button. Select the pan to set the cooking process.
5. Select a preset function or set the time and temperature manually
for the pans one by one. Then touch the start buttons to start
cooking.
6. For cooking of some ingredients, it may require turning the
contents in the basket or adding small quantity of oil in the cooking
ingredients during the cooking process to ensure even cooking and
avoid charring of ingredients positioned at the top of the basket.
When this is needed, you can pull out the pan. The appliance will stop
heating automatically. After turning or adding oil, place the pan back
into the appliance to resume cooking.
NOTE: you may slide out the pan to check at any time during the
cooking process. The appliance will pause when the pan is taken out
or powered off. The appliance will continue the cooking process if the
pan is slide in and it will power on again.
7. You can reset the time and temperature setting during the cooking
process if required.
8. When you hear the "beep-beep" sound, the set time is elapsed,
and the cooking cycle is completed. The appliance is now in standby
mode.
9. Check if the ingredients are cooked to your satisfaction. If not, set
the timer for a few more minutes until the ingredients are cooked to
your satisfaction.
10. Remove the pan from the appliance. Only hold by the handle as
other surfaces will be hot. Place the pan on a flat, firm, and heat-
resistant surface. During the cooking process, oil from food will drip
and be collected on the bottom of the pan. This can be cleaned at the
end of the cooking process when the pan cools down.
11. After using your appliance, remove the plug from the wall socket
immediately and allow the appliance to cool down completely.
CAUTION!
Beware of escaping steam from the pan, as there is a danger of
scalding.
13
EN